AQDEXZ - Flat Surfaces:


AQUA Drill EX for Counter Boring: Speeds & Feeds Calculator - Nachi LIST # L9610, L6911

Material to Machine:

Drill Diameter (Decimal Format)

Suggested Starting Parameters

SFM  
V  
RPM  
IPR  
IPM  
MM/Rev  
m/min  
f(%/D)  
 
Notes:
  1. Use calculated drilling conditions as a generall guide, when starting operation.
  2. Adjust drilling conditions accordingly to the rigidity of machine or work clamp site.
  3. When drilling Drilling Angled surfaces use calculated table values based on your angle of entry.
  4. When drilling Curved surfaces use calculated table value for curved surfaces.
  5. Aqua Flat drills cannot be used for pocket milling.

Decimal Converter

MM = 0 Decimal Eqiv.

AQDEXZR - Flat Surfaces:


Speeds & Feeds Calculator - Nachi LIST # L9818, L9816

Material to Machine:

Drill Diameter (Decimal Format)

Suggested Starting Parameters

SFM  
V  
RPM  
IPR  
IPM  
MM/Rev  
m/min  
f(%/D)  
 
Notes:
  1. Use calculated drilling conditions as a generall guide, when starting operation.
  2. Adjust drilling conditions accordingly to the rigidity of machine or work clamp site.
  3. When drilling Drilling Angled surfaces use calculated table values based on your angle of entry.
  4. When drilling Curved surfaces use calculated table value for curved surfaces.
  5. Aqua Flat drills cannot be used for pocket milling.

Decimal Converter

MM = 0 Decimal Eqiv.

AQDEXZOH3D - Flat Surfaces:


Speeds & Feeds Calculator - Nachi LIST # L9812, L9814

Material to Machine:

Drill Diameter (Decimal Format)

Suggested Starting Parameters

SFM  
V  
RPM  
IPR  
IPM  
MM/Rev  
m/min  
f(%/D)  
 
Notes:
  1. Use calculated drilling conditions as a generall guide, when starting operation.
  2. Adjust drilling conditions accordingly to the rigidity of machine or work clamp site.
  3. When drilling Drilling Angled surfaces use calculated table values based on your angle of entry.
  4. When drilling Curved surfaces use calculated table value for curved surfaces.
  5. Aqua Flat drills cannot be used for pocket milling.

Decimal Converter

MM = 0 Decimal Eqiv.